Eagle CAD: System Bd. 4 Schematic
A
Eagle CAD: System Bd. 4 Schematic B
Final System Test
(Click for a short video)
|
Expansion Board
Board 4
was designed for expansion/development.
You can
run jumpers from Board 1's female SIP connector to Board 4's
female DIP connector.
There
is also as JST I2C connector on Board 3 that could connect
directly to either a breadboard or Board 4's dev area; lots of
choices.
System Final Test
As a
final test of your M4 Cube, run
x_Weather_Inside_M4_h.ino.
If
you're running an OLED using the SSD1306 driver chip, you're all set.
If
you're running an OLED using the SH1106 driver, you'll need to
comment out line 66 with "//" and remove the comment characters (//) from line
65.
|